| 一般及合集(General) | Ver. | Description | Lang. | Update |
|
AP-GAXXXX_06CV10.pdf
| 1.0 | TM87 & TM89 系列 Application Note -
OTP IC燒錄注意事項
| 繁(TC) | |
|
AP-GAXXXX_06EV10.pdf
| 1.0 | TM87 & TM89 series Application Note –
Points for attention in using OTP IC Program | 英(EN) | |
|
AP-TM87ICE01CV11.pdf
| 1.1 | 如何在TM87 ICE and DEMO BOARD 上量測與調整oscillator的頻率 | 繁(TC) | |
|
AP-TM87ICE01EV11.pdf
| 1.1 | How to measure and adjust the frequency of oscillator on TM87 ICE and DEMO BOARD | 英(EN) | |
|
AP-TM87XX_01CV11.pdf
| 1.1 | TM87系列產品，應用於3V電源，LCD 1/3 bias。裝上電池時發生power on reset不良問題之對策。 | 繁(TC) | |
|
AP-TM87XX_01EV11.pdf
| 1.1 | TM87 series 4 Bit Microcontroller Application Note-
The solution to the “power on reset” problem during installing the battery procedure in 3V power supply and LCD 1/3 bias application。 | 英(EN) | |
|
AP-TM87XX_02CV13.pdf
| 1.3 | TM87系列產品，應用於3V電源，LCD 1/3 bias。當BCF flag被clear為0時，Crystal oscillator因受外界干擾造成停振後無法起振之對策 | 繁(TC) | |
|
AP-TM87XX_02EV13.pdf
| 1.3 | The solution to “How to avoid the Crystal oscillator being stopped by external interference when BCF flag is cleared to 0?” as TM87 series products applying to 3V power supply and LCD 1/3 bias. | 英(EN) | |
|
AP-TM87XX_09EV13.pdf
| 1.3 | How to implement the transmission of UART on TM8725, TM8726 and DEMO BOARD | 英(EN) | |
|
AP-TM87XX04EV11.pdf
| | Load capacitance and frequency tolerance of 32,768Hz Crystal Oscillator | 英(EN) | |
|
AP-TM87XX04VC10.pdf
| | 32,768Hz Crystal Oscillator在應用時的匹配電容與誤差值 | 繁(TC) | |
|
AP-TM87XX05EV11.pdf
| | The application of large-sized LCD panel | 英(EN) | |
|
AP-TM87XX05VC10.pdf
| | 大面積之LCD panel的應用 | 繁(TC) | |
|
AP-TM87XX08EV11.pdf
| | BCF flag | 英(EN) | |
|
AP-TM87XX08VC10.pdf
| | BCF flag的設定時機與影響 | 繁(TC) | |
|
AP-TM87XX09VC10.pdf
| 1.0 | 如何在TM8705 ,TM8706 and DEMO BOARD 上實現UART的傳輸 | 繁(TC) | |
|
AP-TM87XX10CV11.pdf
| 1.1 | 大面積之LCD panel 應用 | 繁(TC) | |
|
AP-TM87XX10EV12.pdf
| 1.2 | The application note for using large-size LCD panel | 英(EN) | |
|
SZ082.zip
| 1.1 | 介紹tenx TM87系列MCU的HALT以及STOP功能 | 簡(SC) | |